How to change the built-in battery of Condor XC-MINI?

Rechargeable battery of XC-Mini is new accessory for Condor XC-MINI key cutting machine,you can buy the chargeable battery and replace it in Condor MINI,then your condor mini can have bulit-in battery.Here is the guide how to change Condor XC-MINI built-in battery. (Get New  Xhorse Condor XC-Mini Plus Key Cutting Machine)


Remark: please follow the procedure to operation in case of damage the Mainboard ,do not connect the power during operation
1 , Take off those 4 screws like the picture show
Attention : For your security, do not connect the power in next steps.


2 , Push the motor inside and hold the white buckle then take out the emergency-stop module like the picture show


3 , Loose the connection of position 11 &12 like picture show

how-to-change-the-built-in-battery-of-condor-xc-mini-4 how-to-change-the-built-in-battery-of-condor-xc-mini-5

4 , Use a screw to make the connection those two cables what are from position 11 & 12 like the picture show ,and use the acetate tape fix the connection well


5, Fix the cable 6 to the position 12 , cable 7 for position 11 , then put the emergency –stop module back and fix it well


6, Take off those 2 screws like picture show


7, Turn over the Condor XC-MINI and take off the foot rubber


8, Take out the Power-board and disconnect all cables like picture show


Original Power interface ( 220V)

Battery charger & display module


9, Use the battery charger & display module to replace the original power interface like picture show


10 , Fix the cable into the socket according the number between the cable and socket ,make sure every cable will be fix well


11, Fix the cable of 24V and cable of GND in the right position like picture show


12, Connection the power like picture show then put back the Mainboard and fix it well


13, Fix the all cables after put back the mainboard , the mainboard should be in fixed very solid ,manage the cables again if not , then fix the foot rubber and screws


14, Fix those screws like picture show


15 , The screen , LED , display of battery charger should be on after you press the emergency – stop button , if not ,check the connection again


Remark : electricity volume will be show by the green light , the LED that is mark ‘’ CHRG ‘’ should be green if it is charged , it will be red during charging0