Some users may find that after updating the Xhorse Multi Prog to Firmware V1.4.9, the device is no longer detected by the software. The programmer may display “UPDATING” and remain stuck in that state. Why it happens? During the V1.4.9… Continue Reading
This guide shows you how to decode and cut a Medeco M3 key using the Xhorse Condor XC-TWINS Key Cutting Machine. Featuring a high-security 6-cut-position design, the Medeco M3 key requires precise angle selection and correct front/rear orientation at each… Continue Reading
Customer Feedback: Xhorse iScancar MM-007 VAG Scanner failed to power on after startup. One user reported that the device displayed a “Battery Low” warning and could not boot normally, even after attempting to recharge it. Is there a solution to… Continue Reading
A user reported that after charging the Xhorse Dolphin XP005 overnight, the battery only reached 3 bars, and after powering on, it immediately dropped to 2 bars. XhorseVVDI.com Engineer’s Reply: This is usually caused by the battery protection mechanism, not… Continue Reading
Failed to back up data from a Porsche BCM 1N35H using the Xhorse VVDI Key Tool Plus. During the backup process, the device failed the self-test and displayed the following errors: Power Module Exception and FPGA Certification Error, preventing the… Continue Reading
Another successful spare key programming with the Xhorse VVDI Key Tool Plus! This time on a 2021 Dodge ProMaster, the process started by reading the 5-digit security PIN, followed by programming all the keys that should remain authorized in the… Continue Reading
Problem: After updating the Xhorse Multi-Prog software to V1.4.2.0 (with the latest database installed), several users have reported unexpected communication issues when working with certain Bosch ECUs, including EDC17CP49, EDC17CP02, and EDC17C50. If you’re experiencing connection failures after the update,… Continue Reading
Question: Has anyone successfully cloned a Peugeot Valeo VD56.1 ECU using the Xhorse Multi-Prog? I can read and write both the flash and EEPROM without any errors, and the writing process completes successfully. However, after installing the cloned ECU, the… Continue Reading
The Xhorse VVDI Super Chip XT27B is a powerful solution for modern key programming jobs… but it is not a universal replacement for every transponder. Many technicians see “Super Chip” and assume it can handle every vehicle. That misunderstanding is… Continue Reading
Lost all keys to a 2012 Toyota Sienna? This step-by-step guide covers the complete AKL process, including mechanical key decoding, precision key cutting with the Xhorse Dolphin XP-005, and transponder programming using the Xhorse VVDI Key Tool Max Pro. Phase… Continue Reading
A damaged remote key for a 2010 Citroen Berlingo can be replaced by generating a new remote with Xhorse VVDI Key Tool Plus and cutting the key blade using the Dolphin II key cutting machine. In this case, the original… Continue Reading
If you updated your Xhorse VVDI Prog software to V5.3.8 and encountered the “Config File Error” or “Not Find Device” message, don’t worry. This issue is usually related to the device connection or driver installation. Follow the troubleshooting steps below… Continue Reading
E-mail:sales@xhorsevvdi.com
Whatsapp: +86-13983756354
Live Chat: Online Service
Skype: xhorsevvdi.com
