V1.2.5 VVDI2 VAG Copy 48 Transponder Operate Guide

 V1.2.5 VVDI2 VAG newly add the function of copy 48,but require VAG 4th immo authorization. Our VVDI2 Full,VVDI VAG both of them can support it.And here is some steps about VVDI2 VAG Copy 48.

vvdi2-quick-start-software

1.Run “VVDI2 Quick Start” icon,and click VW car brand.Or run directly the VVDI2 Vag software icon.

2.Click “Key learn”>>”4th immobilizer system – copy 48 transponder”

vvdi-vag-copy-48-transponder-1

3.Copy 48 procedure require PIN and component security bytes from cars.

4.Select Get component security from engine control unit via obdii.

5.Connect the emulator to VVDI2 commander and switch ON ignition with the emulator, switch OFF/ON for 3 times

(attention: it requires OBD when lost all key).

6.Decode the collected data via internet, and save the calculate 48 data. You can copy/prepare key with calculate 48 data(attention: every success calculation will cost 100 remote points).

vvdi2-vag-copy-48-transponder-2

7.Learn the new key with calculate 48 data. If the key was made by copy, it can start engine without learn.

vvdi-vag-copy-48-transponder-3

Sales xhorsevvdi.com