Xhorse Dolphin XP-005 Noise and Rough Key Cutting Solution

Q:

Dolphin XP-005 key cutting machine produces strange noises when it begins and finishes working. Besides, the edge of keys cut by it is rough, quite different from before.

 

xhorse-dolphin-xp-005-noise-and-rough-key-cutting-solution-1

xhorse-dolphin-xp-005-noise-and-rough-key-cutting-solution-2

 

The solution from Xhorsevvdi technical support:

Step 1

Remove the back cover of the machine.

Care the cables inside.

xhorse-dolphin-xp-005-noise-and-rough-key-cutting-solution-3 xhorse-dolphin-xp-005-noise-and-rough-key-cutting-solution-4

 

Step 2

Clean iron filings inside by a soft brush instead of a air gun.

Particularly clean filings on here.

xhorse-dolphin-xp-005-noise-and-rough-key-cutting-solution-5

 

Step 3

Lube ball screw and guide rail of the motor.

Restore XP005 key cutting machine.

 

Then noises should disappear and keys cut should be fine.

 

PS. If your Xhorse Dolphin XP-005 met Error like these “Error: 56” “error code: 6”, you can do detecting abnormal conductivity on the Dolphin xp005 probe and milling cutter

Here is the full procedure to test abnormal conductivity of the cutter/probe:

https://www.xhorsevvdi.com/service/detecting-abnormal-conductivity-on-xp005-probe.html

 

Sales xhorsevvdi.com